DIY 10 Car Maintenance Tasks You Can Do Yourself

Car maintenance is one aspect of vehicle ownership so crucial that it should never be joked with, especially in Indonesia, since driving conditions range between crowded city streets to rugged rural roads. While that is always well worth a visit to your professional mechanic when the repairs are complex, much routine maintenance can nonetheless be done in the home and will save money and time. The car would run without hiccups and last longer, with the right equipment applied and just a little bit of know-how. The idea behind this article is to take one through some basic 10 car maintenance tasks that one can easily do by oneself, even with less experience in working with cars.

1. How to Check and Change Engine Oil

One of the easiest, most straightforward routine maintenance procedures you can do is to check and replace your car’s engine oil. The oil is what keeps all the parts of your engine greased and running; otherwise, they would seize up and wear out in no time. Of course, over time the oil becomes dirty and less effective; therefore, it needs to be replaced at periodic intervals.

How to do it:

• Locate the oil dipstick; this is usually colored bright, with a bright handle attached to it.
• Pull it out, clean it, and insert it again.
• Again, pull it out for a check on the level of the oil inside. When it is low, this could be an indication that you have to add more oil.
• Changing the oil means you need to drain the old one to refill with fresh ones. Always use the type recommended by your car’s manual.

Tools Needed: Oil wrench, drain pan, new oil filter, and fresh oil.

Also Read: Top 10 Low Maintenance Cars in Indonesia

2. Replacement of Air Filters

The air filter works to block dirt and other elements that would enter your car’s engine. When this air filter gets clogged, then it reduces fuel efficiency and creates poor performance with the engine of the car. It’s a pretty simple replacement but does make quite a difference to the running condition of your car.

How to do it:

• Pop open the hood of your car and find the box that contains the air filter of your car.
• This is typically a black box located alongside the engine.
• Open this and remove the old filter inside it; replace it with a new one.
• Make sure the new filter is properly fitted before you shut the box.

Tools needed: Normally, special tools are not necessary.

3. Windshield Wiper Check and Replacement

A decent pair of windshield wipers is a must-have at least for the rainy season in Indonesia. Over time, the wiper blades wear out and are possibly smearing or just aren’t cleaning the windshield well.

How to do it:

• Pull the wiper arms away from the windshield.
• Press the wiper blade release tab and slide the blade off the arm.
• Slide the new blade onto the arm until it clicks into place.

Tools Needed: None.

4. Tire Pressure Check and Inflation

Correct tire inflation level has a direct link to safety and economy of running the vehicle. Under-inflated and over-inflated tires will wear out in uneven ways and also be more difficult to control.

How to do it:

• Using the tire pressure gauge, check each tire for pressure. This recommended pressure by the manufacturer usually is on a sticker inside the door of the driver or inside the owner’s manual.
• In case of too low pressure, fill up the tires with air using a portable air compressor or at a filling station to the recommended pressure.

Tools Needed: Tire pressure gauge and air compressor (optional).

5. Tire Rotation

The regular rotation of tires can even out the wear and tear, thus prolonging life for your tires and making your car’s road-handling capability better. It is highly advisable that this should be done every 10,000 kilometers.

How to do it:

• Jack up the car and remove the wheels.
• Rotate the tires in a pattern recommended with your car-usually from front to rear and vice-versa.
• Put the wheels on and lower the car.

Tools Needed: Car jack, lug wrench

6. Replacing Brake Pads

Bad or worn-out brake pads reduce the stopping power of your vehicle. Next, such conditions may lead to further damage to the braking system. You are able to replace them in your garage with some elementary mechanical knowledge.

How to do it:

• Jack up the car and remove the wheels.
• Remove the brake caliper in order to reach the pads.
• Remove the old pads and install a new one; afterwards, put the caliper and wheels back in place.

Tools Needed: jack, lug wrench, socket set, and a new set of brake pads.

7. Battery Check and Cleaning

It forms one of the essential parts of your car, more especially for ignition and electrical setups of your engine. Regular maintenance on your battery, like removing corrosions on its terminals, prevents your sudden breakdown.

How to do it:

• Begin by opening the hood of your car and looking for your battery.
• View terminals for corrosion. If it exists, clean with wire brush and mixture of baking soda and water.
• Ensure battery connections are tight.

Tools Needed: Wire brush and baking soda, water

8. Headlights or Taillights Replacement

Driving around with a burned-out headlight or taillight isn’t just dangerous-it’s also illegal. Fortunately, this light replacement is easy and doesn’t require a trip to the mechanic.

How to do it:

• Open the hood or trunk to access the back of the light assembly.
• Remove the old bulb by twisting it counterclockwise and pulling it out.
• Insert the new bulb and twist it clockwise to secure it.

Tools needed: New bulbs (check your manual for the correct type).

9. Spark Plug Replacement

Spark plugs ignite the fuel in your car’s engine. When they wear out, your car may not start or may run rough. Replacing spark plugs is somewhat of an easy task that helps in smoothing the operation of the engine.

How to do it:

• Locate the spark plugs, usually found on top of the engine.
• Use a socket wrench to remove the old plugs.
• Insert the new plugs and tighten them, but don’t overtighten.

Tools needed: Socket wrench, spark plug socket, new spark plugs

10. Flushing and Replacing Coolant

It keeps the temperature of the engine low and avoids overheating; it may get dirty or the efficiency reduced after some time. Therefore, periodic flushing and replacement of coolant become necessary.

How to do it:

• Locate the radiator drain plug and place a drain pan underneath it.
• Open the plug and let the old coolant drain out.
• Close the plug and refill the radiator with fresh coolant.

Tools needed: Drain pan, funnel, fresh coolant.

Also Read: Most Underrated Cars in Indonesia

Conclusion

Maintaining your car does not need to be a ridiculously complicated or expensive affair. Spending time doing those minor maintenance things yourself can save you many dollars and stop huge ones from developing in your car. These exercises range from simple checks of tire pressure and replacement of air filters to the more involved jobs of changing the brake pads or spark plugs, which can be done with basic tools and a bit of patience. Whether it is a small city car or an SUV that one drives in Indonesia, caring for the vehicle would keep it reliable and safe for all driving escapades. Pull out those wrenches now and begin car maintenance; you will be glad you did!